2017 M1 driver head | M3 Rescue | Fuji and UST shafts

Johnny T · April 17, 2019

Prices are paypaled and shipped to US only. Not interested in any trades. No international shipping.

**1) Taylormade 2017 M1 head** - 10.5* - Club used for a couple of seasons. Shows typical wear on the sole and face. There is a spot on the toe end of the face where it appears the black finish is starting to rub off. Hadn't noticed it until I was taking pics. Topline is clean. Crown has some very faint marks from pulling the headcover on/off but otherwise is clean. **Sold**.

**2) Taylormade M3 Rescue** - 2/17* - Shafted with a KBS Tour Hybrid Prototype 95x. Plays 41". Grip is a gray/red TM GP TV 360 with a lot of life left. Relatively light wear to the sole and face. There is a paint nick on the toe and what appears to be a clear coat chip near the hosel (in the gray area of the crown).

Willing to split

**

Head only - SOLD

Shaft - $80**

**Shafts**

**3) Fujikura Speeder Pro XLR8 63 - xstiff** - .335 tip. Shaft is tipped 1" and played 45" in the above M1. TM adapter included. There is some prep area visible above the adapter. Grip (Iomic sticky 2.3) has a whole in the butt end (had to remove a loose piece of epoxy) so you may want to replace. **$50**.

**4) UST Mamiya Attas Elements DK6x** - This was one of the Attas Element prototype shafts (later became the Attas Elements Wind). .335 tip (no tipping). Raw length is 43 3/8" and played 45" in a Titleist 913D2. Grip is a Lamkin Crossline full cord will a hole in the butt end. **$50**.

**5) UST Mamiya Elements Chrome 9F5T (xstiff)** - .335 tip. Tipped 1" IIRC. Raw length is 41.25" and I think it played 42" in a Cobra fairway. Grip is a black/blue GP VDR with some life left. **$50**.

**My apologies for the out of order photos...not sure what is going on.**