Miura Baby Blade 1-PW

[Kingcat990]

Brand new. Heads reamed. Ready for shafts. Not looking for trades and will not break set up. You get the whole 1-PW set.

 

$1800

 

 

[KAndyMan]

Very cool!! Dont see too many sets like that very often.

[bladehunter]

Shut the front door !

[deep18]

Wow . Seriously.

[SBH9458]

Beautiful. Just beautiful. And I wish I could pick them up!!!!

[Ben Berube]

Bladehunter was up all night trying to scrounge some Xmass $ for himself lol.

Tell you what. You see an opponent walk up with these sticking out of their bag. With a couple long irons looking similar to what butter your toast just an hour earlier. Better fork over the losses after negotiations!

[santasquatcha]

Wowww. Someone should buy these heads to just mount on the wall in a display case. Beautiful, I am not worthy..

[calfan36]

Baby blade 1 Iron ?

[freddy1682]

Reamed to what size? I assume .370?

[shoreline9]

Probably .355, since Miura’s come from the factory just a shade smaller that .355

[md1m]

When I'm good enough to hit a baby blade 1 iron I will call you.

[Bogey London]

Oh, 1 iron :(

[kcsf]

Darn. If they were only LH.

 

 

/s

[swgolf12]

Probably .355, since Miura’s come from the factory just a shade smaller that .355

 

According to the rep that served the place I used to work at they come at .350

[Kingcat990]

They come under .355 like mentioned above. They need a slight ream before fitting for shafts.

[freddy1682]

They come under .355 like mentioned above. They need a slight ream before fitting for shafts.

 

Gotcha. My set must have been done before then. .355 fit like a dream

[calfan36]

They come under .355 like mentioned above. They need a slight ream before fitting for shafts.

 

Why do they do that?

[victrc]

What is the loft on the 1 iron and 2 iron. Haven’t been able to find specs

 

[mmckee02]

I just spit my wine out. Great set!

[JoeJoeJoeUrBoat]

I am running short on butter blades in my kitchen, might be able to use these instead?

[eaglestan66]

The heads require reaming so to have a snug, somewhat friction fit of the shaft against the hosel.

For Precision fitting!!