TS3 Fairway Wood Missing Plug on bottom?

[luke1333]

Just purchased a brand new TS3 online for a good deal and took plastic off and didn't look at it real well. Played a couple rounds with it and noticed today that there is maybe a little plug missing on the bottom? Looked at one in pro shop and online and appears it is. Anybody know where I can buy one or maybe somebody that does hotmelting would have an extra or just a plastic dowel plug? Any suggestions would be great thanks!

 

 

 

[Dreadzombie]

Definitely contact titleist as well, they should be able to help ya out

[SUPERG]

I’ve had a couple of heads arrive with the hot melt plug fallen off, I usually just cover the hole with some black epoxy

[luke1333]

> @SUPERG said:

> I’ve had a couple of heads arrive with the hot melt plug fallen off, I usually just cover the hole with some black epoxy

 

Interesting i guess it is somewhat normal then?

[SUPERG]

> @luke1333 said:

> > @SUPERG said:

> > I’ve had a couple of heads arrive with the hot melt plug fallen off, I usually just cover the hole with some black epoxy

>

> Interesting i guess it is somewhat normal then?

 

Yea it happens, my heads were wrapped off a tour van so maybe they forgot to plug after hot melt. But I’m sure titleist will make it right, the risk would be getting debris in there and over time adding weight.

[Booker]

What I do is belt sand a plastic tee to fit in the hole very snug, should go in about a 1/4 inch or less I heat exposed tee a little and cut it flush with a sharp blade.

[luke1333]

> @Booker said:

> What I do is belt sand a plastic tee to fit in the hole very snug, should go in about a 1/4 inch or less I heat exposed tee a little and cut it flush with a sharp blade.

 

I was a plastic dowel which is same idea I'll give it a try thanks