Fubuki 73 made for taylormade shaft???

[taygolf52]

What are everyones thoughts on this shaft?

So I am thinking about going with an R9 and I wanted to know what everyone thinks about this shaft? How different is it a stock Fubuki? weaker? stronger? the same?

Just looking for opinions to see if I should go with this customization or just get the cheapest shaft possible in it and then change it to what I want later

Thanks

T

[Pepperturbo]

The Fubuki that TM offers isn't the same as the aftermarket Fubuki; I owned both 73's and sold them.

I believe slightly higher torque is better for most golfers vs. low TQ. TM dropped the torque considerable in the 63 from 3.7 in the aftermarket oem version to 3.1 in TM version; and they did that in their 73 Fubuki only not as much; that equates to a stiffer tip section. I didn't like the Fubuki trajectory, so I sold it; but that's just me.

Knowing that most OEM club club makers buy in volume to spec, I will never custom order from them again. I custom ordered a DBB from Titleist and got a tipped 4" tip version. I spoke with them and they assured me it was the same but because I didn't know what exactly they did to the shaft I sold it.

If you're going to go with an upgrade aftermarket shaft, I suggest buy TM's standard TP and get the shaft later. Remember, standard TM sleeve is .350 and TP is .335.