Jump to content

Question on pulled UST Recoil 95 Iron Shafts - tip prep doesn's insert fully into Ping hosels


jb93
 Share

Recommended Posts

Bought a set of pulled Recoil 95 to install into Ping G2 irons.  The tip prep does not insert all the way into hosel.

 

I know these tapered shafts are meant to be butt trimmed only, but could I get away with trimming 1/4" off of tips

or maybe better to just mask off and spray with chrome spray paint to closely match the finish.

 

Installing ferrules is a no-go as the hosel is angled.  Fit would be a nightmare.

Link to comment
Share on other sites

Posted (edited)
19 minutes ago, KarstenK said:

Did you buy .370 instead of .355? And yes Pings didn't come with ferrules until last few years I think.

No, I purchased the correct 0.355 tapered.  The paint is sanded off for install into the irons they came out of and that does not insert all the way into the Ping hosel so it looks rough at the junction (covered by ferrule in irons shafts came out of).  I can either tip trim them 1/4" (not recommended by mfr) or spray with chrome spray paint to blend it in best I can.

Edited by jb93
Link to comment
Share on other sites

3 minutes ago, jb93 said:

No, I purchased the correct 0.355 tapered.  The paint is sanded off for install into the irons they came out of and that does not insert all the way into the Ping hosel so it looks rough at the junction (covered by ferrule in irons shafts came out of).  I can either tip trim them 1/4" (not recommended by mfr) or spray with chrome spray paint to blend it in best I can.

Gotcha, yeah sometimes Pings took a firm push to click into the base of the hosel but not sure why they wouldn't be seating down in it. Tipping them would be a bad idea IMO. Good luck.

Ping g410 Lst 9* 
Ping G410 14.5* 
Ping G410 hybrid 19* 
Srixon ZX5 4-AW 

Cleveland CBX2 54* 
Titleist SM7 58* Slate Blue
SC Select Newport II Midslant

Link to comment
Share on other sites

4 hours ago, jb93 said:

They seat down...the tip was just previously prepped for irons that had a ferrule.  So now that sanded off painted area shows at the junction of Ping hosel and shaft.  I think I will chrome spray paint them and call it good nuf.

Simplistic solution

 

legendary G2 irons & Recoil sounds like a solid combo

  • Like 1

Ping Sunday Bag
9 Clubs of Freedom

Link to comment
Share on other sites

12 hours ago, jb93 said:

Bought a set of pulled Recoil 95 to install into Ping G2 irons.  The tip prep does not insert all the way into hosel.

 

I know these tapered shafts are meant to be butt trimmed only, but could I get away with trimming 1/4" off of tips

or maybe better to just mask off and spray with chrome spray paint to closely match the finish.

 

Installing ferrules is a no-go as the hosel is angled.  Fit would be a nightmare.

 

If the problem is that the insertion depth of your irons are less then the insertion depth of the irons they were prepped for  (it's really inserted all the way to the bottom of the hosel but some tip prep is still showing) then sure go ahead and tip trim a bit to clean it up.   That's not going to be any problem at all.  You'll probably have to reshape the taper - but the Ping taper is so non-standard that it's usually best to do that anyways.

 

If the tip of the shaft really is not making it all the way to the bottom of the hosel, then tip trimming is not the right solution.  You need to reshape the tip until it does insert all the way to the bottom of the hosel.

Edited by Stuart_G
  • Like 3
Link to comment
Share on other sites

In addition to what Stuart_G stated, Ping's like the G2 have an interference fit hosel such that the shaft needs to be driven into the head in order to get it to bottom out.  With graphite shafts you can sand the tip a little to allow the shaft to seat so you don't need to pound the shaft into the head.  That's what I do anyway.  

 

If you decide to tip the shafts 1/4" or so so the tip prep will be hidden it's doubly important to sand the tips down a little.  Only about 1/4" of the tip needs to be sanded, not the whole tip.  It's very easy to do.

  • Like 2

Ping G400 Max driver w/Aldila Rogue 125 Silver 60S
Cobra (Lexi blue) F7 4 wood w/Aldila Rogue Black 70S
Cobra (Lexi blue) F7 Hybrid w/Aldila Kuro Kage 80S
Ping G410 irons w/Recoil 95S
Ping Glide 55/60 wedges w/Recoil 110S
Ping Anser - the "real deal!"

Link to comment
Share on other sites

On 7/24/2021 at 9:09 PM, animalgolfs said:

Simplistic solution

 

legendary G2 irons & Recoil sounds like a solid combo

Thank you.  I love the old G2s and the new Recoils.  I had to give it a shot with some inexpensive pulls off Ebay.  I ended up painting the prepped area that would not insert into the G2 hosel gloss black so that it is a "faux ferrule" look.  They are curing up now.  

  • Like 1
Link to comment
Share on other sites

29 minutes ago, jb93 said:

Follow up question.... I used 24 hour epoxy and my garage is 80-95 degrees so plenty hot for curing.  My left over epoxy

was already hardened up this morning after 12 hours.  Am I safe to hit them at the 24 hour mark or should I wait 48 hours?

I'd be surprised if they're not good to right now.....I use tour set w/beads and I've always good at 12hrs

Ping Sunday Bag
9 Clubs of Freedom

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

  • Recently Browsing   0 members

    No registered users viewing this page.

  • Our picks

    • 2021 CJ Cup at The Summit Club - Discussion and Links
      Please put any questions or comments here
       
       
      2021 CJ Cup at The Summit Club - Tuesday #1
      2021 CJ Cup at The Summit Club - Tuesday #2
       
       
      Adam Scott - WITB - 2021 CJ Cup at The Summit Club
      Justin Rose - WITB - 2021 CJ Cup at The Summit Club
      Collin Morikawa - WITB - 2021 CJ Cup at The Summit Club
      Jason Day - WITB - 2021 CJ Cup at The Summit Club
      Justin Thomas - WITB - 2021 CJ Cup @ The Summit Club
      Erik Van Rooyen - WITB - 2021 CJ Cup @ The Summit Club
      Matt Jones - WITB - 2021 CJ Cup at The Summit Club
      Cam Davis - WITB - 2021 CJ Cup at The Summit Club
      Cam Smith - WITB - 2021 CJ Cup at The Summit Club
      Byeong Hun An - WITB - 2021 CJ Cup at The Summit Club
      Min Kyu - WITB - 2021 CJ Cup at The Summit Club
      Joohyung Kim - WITB - 2021 CJ Cup @ The Summit Club
      Tommy Fleetwood - WITB - 2021 CJ Cup @ The Summit Club
      Jordan Spieth - WITB - 2021 CJ Cup @ The Summit Club
      Lucas Glover - WITB - 2021 CJ Cup @ The Summit Club
      Keegan Bradley - WITB - 2021 CJ Cup @ The Summit Club
       
       
       
      Gary Woodland's new Cameron putter - 2021 CJ Cup @ The Summit Club
      Kevin Na's new Odyssey/Toulon putter - 2021 CJ Cup @ The Summit Club
      Jucie wedges & Proto irons - 2021 CJ Cup at The Summit Club
       
       
       
       
      • 6 replies
    • 2021 Shriners Hospitals for Children Open WITB Photos- Discussion & Links
      Please put any questions or comments here...
       
      Links:
       
      Harry Higgs - WITB - 2021 Shriners Hospitals for Children Open
      Ian Poulter - WITB - 2021 Shriners Hospitals for Children Open
      Corey Conners - WITB - 2021 Shriners Hospitals for Children Open
      Harry Higgs - WITB - 2021 Shriners Hospitals for Children Open
      Matt NeSmith - WITB - 2021 Shriners Hospitals for Children Open
      Doug Ghim - WITB - 2021 Shriners Hospitals for Children Open
      New Cameron Las Vegas covers - 2021 Shriners Hospitals for Children Open
      New Project X HZRDUS Smoke RDX shafts - 2021 Shriners Hospitals doe Children Open
       
       

       
        • Like
      • 14 replies
    • 2021 Sanderson Farms Championship - Discussion and Links
      2021 Sanderson Farms Championship - Monday
      2021 Sanderson Farms Championship - Tuesday #1
      2021 Sanderson Farms Championship - Tuesday #2
      2021 Sanderson Farms Championship - Tuesday #3
       
      2021 Sanderson Farms Championship - Tuesday #4
       
      WITBs
      Aaron Rai - WITB - 2021 Sanderson Farms Championship
      Brian Stuard - WITB - 2021 Sanderson Farms Championship
      Eugenio Chacarra - WITB - 2021 Sanderson Farms Championship
      Davis Riley - WITB - 2021 Sanderson Farms Championship
      Brice Garnett - WITB - 2021 Sanderson Farms Championship
      Curtis Thompson - WITB - 2021 Sanderson Farms Championship
      Richy Werenski - WITB - 2021 Sanderson Farms Championship
      Andy Ogletree - WITB - 2021 Sanderson Farms Championship
      Sahith Theegala - WITB - 2021 Sanderson Farms Championship Will Zalatoris - WITB - 2021 Sanderson Farms Championship Stephan Jaeger - WITB - 2021 Sanderson Farms Championship Kevin Chappell - WITB - 2021 Sanderson Farms Championship Jonas Blixt - WITB - 2021 Sanderson Farms Championship Kevin Streelman - WITB - 2021 Sanderson Farms Championship Sam Burns - WITB - 2021 Sanderson Farms Championship Matthew Wolff - WITB - 2021 Sanderson Farms Championship Jimmy Walker - WITB - 2021 Sanderson Farms Championship Gary Woodland - WITB - 2021 Sanderson Farms Championship Davis Thompson - WITB - 2021 Sanderson Farms Championship Sam Saunders - WITB - 2021 Sanderson Farms Championship  
      Special Galleries
       
      Odyssey putters - 2021 Sanderson Farms Championship  
      Cameron putters - 2021 Sanderson Farms Championship  
        • Like
      • 5 replies
    • 2021 Fortinet Championship - Discussion and Links
      Please put and questions or comments here
       
       
      2021 Fortinet Championship - Tuesday #1
      2021 Fortinet Championship - Tuesday #2
      2021 Fortinet Championship - Tuesday #3
      2021 Fortinet Championship - Tuesday #4
      2021 Fortinet Championship - Tuesday #5
      2021 Fortinet Championship - Tuesday #6
      2021 Fortinet Championship - Tuesday #7
      2021 Fortinet Championship - Tuesday #8
       
       
      New Ping putter - 2021 Fortinet Championship
      New Bettinardi putters & Cover - 2021 Fortinet Championship
      Ping Putters - 2021 Fortinet Championship
      Odyssey putters - 2021 Fortinet Championship
      Cameron putter and new ball marker - 2021 Fortinet Championship
       
       
      Sneds - WITB - 2021 Fortinet Championship
      Peter Uihlein - WITB - 2021 Fortinet Championship
      Charles Howell, III - WITB - 2021 Fortinet Championship
      Scott Piercy - WITB - 2021 Fortinet Championship
      Brandan Steele - WITB - 2021 Fortinet Championship
      Mito Pereira - WITB - 2021 Fortinet Championship
      Kevin Tway - WITB -2021 Fortinet Championship
      Joseph Bramlett - WITB - 2021 Fortinet Championship
       
       
       
      • 19 replies
    • 2021 Tour Championship - Discussion and Comments
      Please put any questions or comments here
       
       
       
       
      Odyssey putters - 2021 Tour Championship
      LA Golf putter shafts - 2021 Tour Championship
       
       
       
        • Like
      • 25 replies

×
×
  • Create New...