Iron recomendations for a thin/low on the face miss

[Lefty87]

On 1/30/2023 at 7:22 PM, chisag said:

 

 

... Back issues can make my miss thin when it is stiff. P790's with the slot sole are more forgiving than any I have played when hit thin. I have a set of '22 Forged Tecs I play every now and then that feel pretty bad when hit really thin although they do produce a useable shot, just not in the same forgiveness category as the P790's. 

I haven’t hit the standard ‘22 Forged Tecs but I have hit the ‘22 Forged Tec X and, for me, they were noticeably more forgiving than the P790. 

[chisag]

12 minutes ago, Lefty87 said:

I haven’t hit the standard ‘22 Forged Tecs but I have hit the ‘22 Forged Tec X and, for me, they were noticeably more forgiving than the P790. 

 

 

... I would agree with the FT X (I have the 4 iron) and the regular FT's are also perhaps a little more forgiving than P790's. I was only referring to low strikes on the face "hit really thin" where the P790's really out perform any other irons I have hit. 

[T_Golf_23]

On 2/13/2023 at 11:40 AM, valmario said:

Edited December 10, 2023 by T_Golf_23

[T_Golf_23]

On 2/13/2023 at 11:40 AM, valmario said:

heres' an update to my journey to find a set of irons that i can use while i get back on track.  i forgot i had purchased a set of single length King Forged Tec One Blacks w/ some steelfibers off of the BST last summer.   I took them for a range session and i think these mioght be a little more agreeable to my limitations.  

Only on WRX does one forget about a whole set of golf clubs…. 

[black bnr32]

9 hours ago, T_Golf_23 said:

Only on WRX does one forget about a whole set of golf clubs…. 

And bump 9 month old threads

[cardoustie]

Ball back in stance

add length to test

graphite shafts

 

ping s55 and Mizuno 919t are my suggestions 

 

i seem to be opposite of a lot of posters … hollow for me was not good on slight this … blueprint, i500, 790 and tmb’s for example

[T_Golf_23]

36 minutes ago, black bnr32 said:

And bump 9 month old threads

I was doing research. I have seen 9yr old threads get bumped - so it’s not that bad 

[Pnwpingi210]

On 1/30/2023 at 4:13 PM, valmario said:

I am coming off a back/neck injury and my "new" swing has me missing thin/low on the face with little to no divot.    

 

I know its mainly a swing flaw where i cant get to my left side hard enough, but I am coming to terms that this may be my new move. 

 

I was wondering if anyone had any suggestions on which irons new or old are on the more forgiving side for shots low on the face and have a relatively thin sole. 

 

I'd assume most of the hollow body irons might be the ticket, but let me know what you all think 

T100/t150 have a lots of mass shoved low and toe side.  About as thin as soles as you will get with that much weight pushed low.