3 Ball SRT Sight line

[jdaniel]

Anyone have a template built for this model?

 

What would be the quickest way to get it done, can't wait long.

[Cameron Circle T]

Measure the width of each ball and find the middle of each one. Then make a small pencil mark in the middle and at each end of each ball along that middle line. Then connect the marks with a ruler or a piece of string and a pencil. Then go over that with a marker once youve determined its where you want it. Thats how I've done it and it worked out well.

[taylormadefan]

Quickest, easiest you say?

 

Go get a T square from a home improvment store

 

Place the horizontal part of the T on the putter's face, and you'll get a perfeclty perpendicular line, every time, guarenteed!

[tanj]

That's what I was going to say, the set square! I can guess that the balls are not 100% lined up, somewhere around 99.9% lined up but a perpendicular line to the face is the best since it is the face that starts the ball in the direction, not the alignment aid. Next time, just get a Bobby Grace. Nice STRAIGHT LINE. Easy!

 

Josh

[Duncan]

How does this look?

 

 

One word of advice, use model paint for painting the lines. DON'T use markers as the stain is quite impossible to remove. You can always use thinner to remove the paint for corrections with good results. Do use the T square method to locate the midpoint. Take you time for good results. Good luck :golfer:

[Cameron Circle T]

Looks like someone used the Dave Pelz Method, lol.

 

 

 

 

 

also the above 3-ball would appear to be a photoshop, the red lines extend into the black areas just barely but create perfectly sharp edges that you can see dont seem to be any lower which they would be if they were into the black.

[jdaniel]

OK, now I'm getting sick. :golfer:

 

I was thinking one black line. I've seen it on a tour players putter.