higher launch/lower spin than 660TR?

[alk3]

redboard? altus?

Iam looking for a new shaft for my tour comp. I hit it on a flat low trajectory that balloons into the wind. I want something that will take off a good bit higher but with much less spin. I liked the 660TR in a launcher 400 but its not working for me in the comp.

I was looking at the diamana redboard or ozik altus. would these shafts fit my requirements?

If i play the X in the 660, what flex should i goto in each of the above shafts?

SS is 110. Dont know ball speed, etc. Carry is only 250 due to not getting a high enough launch angle.

Any help appreciated..thanks in advance.

[gslabbert]

I struggled for about a year to find a shaft that lowered the trajectory and bored out. I only found 2. The speeder 757 and the Accra sc75, but I am sure that there are a few other shafts, but I know that these 2 work in that head.

[joey3108]

Iam looking for a new shaft for my tour comp. I hit it on a flat low trajectory that balloons into the wind. I want something that will take off a good bit higher but with much less spin. I liked the 660TR in a launcher 400 but its not working for me in the comp.

 

I was looking at the diamana redboard or ozik altus. would these shafts fit my requirements?

 

If i play the X in the 660, what flex should i goto in each of the above shafts?

 

SS is 110. Dont know ball speed, etc. Carry is only 250 due to not getting a high enough launch angle.

 

Any help appreciated..thanks in advance.

I have to be honest w/ you, I rarely see 660TR balloon on a driver especially if you hit it low already.

 

It could be you need a stiffer shaft ( over powering the shaft from a quick compact swing ) or You have a tendency of descending blow at impact or it could be as simple as teeing the ball to low that causing you to hit down on the ball or maybe event as simple as ball position at address.

 

W/ you 110mph ss, your potential to gain distance is huge from 250...however you really need to be more critical to find the cause first.

 

Joe

[ifixclubs]

check out the accra se80*....has a more active tip section and low torque...