Basic ??? about reshafting.

[ilikegolf]

What drill bit size do you guys use to remove epoxy

What drill bit size is needed in order to get the epoxy out from the tips of graphite shafts.

I assume its the smalllest drill bit size available am i right? Any particular type of bit work better than others?

Any tricks to remove epoxy out from the hosels also?

Just want to cover all the bases before i actually start partaking in this hobby.

Thanks.

[barkleybuff]

The smallest wood or metal drill bit you have would work for the inside of the shaft. Most often, all of the epoxy will fall out while drilling. For the inside of the clubhead i general use a bit that fits a little loose...but not too loose inside the head. Clean it out lightly and then use sand paper or a wire brush to finish the job. Best Wishes and good Luck.