Question on reshafting with Project X 6.0 and choosing shafts to install

bk3318 · April 20

I have a set of Titleist T150 that I want to reshaft into the Project X 6.0. I am looking to buy the shafts on Ebay and I am seeing many 4-PW sets. Since I have two wedges, PW and GW, would the 4-PW set work? Or would I have to buy a set of 5-PW and use another PW shaft for the GW? I hope what I am asking makes sense. TIA

bladestriker · April 20

What is your set make up?

The problem you might run into if you get a 5-PW set, is installed length. I typically us a wedge shaft for both gap and pitching wedge.

bk3318 · April 20

44 minutes ago, bladestriker said:

What is your set make up?

The problem you might run into if you get a 5-PW set, is installed length. I typically us a wedge shaft for both gap and pitching wedge.

5-PW and GW

so get 5-W and an extra W for the GW?

bladestriker · April 20

1 minute ago, bk3318 said:

5-PW and GW

so get 5-W and an extra W for the GW?

That's what I would do, although I have soft stepped on stronger lofted irons due to them being a traditional set with a different number on the bottom.

There is no right or wrong, if you got the 4-pw, the shafts would be soft stepped once with minimal, if any, difference in performance.

CBMC · April 20

2 hours ago, bk3318 said:

I have a set of Titleist T150 that I want to reshaft into the Project X 6.0. I am looking to buy the shafts on Ebay and I am seeing many 4-PW sets. Since I have two wedges, PW and GW, would the 4-PW set work? Or would I have to buy a set of 5-PW and use another PW shaft for the GW? I hope what I am asking makes sense. TIA

I would also add be cautious if buying used. I bought a set that was basically brand new looking pulls. Unknown to me they where already soft stepped to standard length(once I got them and checked the model number). The set was sold 4-pw but was actually 3-9 cut 1/2 inch short. Since I payed $12 per shaft I wasn't too upset.