Help with the numbers

[BrianM18]

Hello, I was hoping someone with more knowledge than me could look at these and see if I am lacking somewhere that I could possibly get a few more yards with the driver. I'm trying to get my SS up, the highest i got up to was 102 but that is not realistic to do every time  so these numbers are a fair average of what is normal for me. 

Not sure if it helps but my driver is an Epic speed at 8 degrees with Diamana D+ limited 60 gram shaft playing 44.75 inches.  Thank you

 

 

  

[Canyonaro]

Try bumping the loft up to 9 degrees. Also this is a straight pull. Consider trying the "D" setting as well (upright lie angle). The upright lie might help you straighten your path without worrying so much about losing it right. Good luck! 

[Stuart_G]

What LM was used?

 

The main thing that pops up to me is the low smash factor of 1.45.    That could mean you need to work on getting better face impact location. 

 

Get out the foot powder spray.

 

 

 

 

 

 

 

[BrianM18]

11 hours ago, Canyonaro said:

Try bumping the loft up to 9 degrees. Also this is a straight pull. Consider trying the "D" setting as well (upright lie angle). The upright lie might help you straighten your path without worrying so much about losing it right. Good luck! 

I will try that idea  thank you  hopefully that can straighten it out a little 

[BrianM18]

4 hours ago, Stuart_G said:

What LM was used?

 

The main thing that pops up to me is the low smash factor of 1.45.    That could mean you need to work on getting better face impact location. 

 

Get out the foot powder spray.

 

 

this was on a trackman ,   my strikes tend to be a little high and toe side   I try to center it out a little bit with this  

 

 

 

 

 

[parl112]

On 1/30/2024 at 9:13 PM, Canyonaro said:

Try bumping the loft up to 9 degrees. Also this is a straight pull. Consider trying the "D" setting as well (upright lie angle). The upright lie might help you straighten your path without worrying so much about losing it right. Good luck! 

This worked for me