Help: Lowest spinning and lowest launch driver combo?

[Matt 3 Jab]

As per the title, i need it.

 

I hit the ball well but very high, strong but spining too much.

 

Current combo is Mizuno MX500 9.5 degree with a Proforce V2 X flex.

 

Thanks all

[geeza_1]

As per the title, i need it.

 

I hit the ball well but very high, strong but spining too much.

 

Current combo is Mizuno MX500 9.5 degree with a Proforce V2 X flex.

 

Thanks all

 

Heads to try:

 

Geek DCT (low launch and very low spin) - my fave, but I went from an 8.5 Taylormade to a 10.5 here with same ballflight.

Bridgestone J33r 460 (mid launch and low spin)

 

As for shafts, that is very personal, so I won't try and confuse you!

[sma1001]

give the ozik x-con shaft a try. may work for you but you need to try first both to get the right weight (5 lightest and heavier as numbers go up) and the flex.

[parmark]

Funny seeing you post this - I just went thru the same exercise. After MUCH insight and searching, ended up going with Tour Edge Exotic 9.0 driver - and the Pro Force V-2 regular shaft.

 

Awesome results. Dropped my spin rate in half! Of course I'm a bit on the weak side, swing speed 85-90. Good luck, let us know what you end up going with.

[heybrady]

J33 460 or Hibore XLtour for low launch and spin heads

 

Whiteboard, PM702, Fuji VT80, Blue for low launch shafts

[keiko]

I like my adams insight 9016D 7.5* with a 48" grafalloy epic stiff shaft.

 

As per the title, i need it.

 

I hit the ball well but very high, strong but spining too much.

 

Current combo is Mizuno MX500 9.5 degree with a Proforce V2 X flex.

 

Thanks all

[Pingnut]

I've hit the Adam's XTD Pro and 9015d - both are very low spin.. the 9015d seem to launch lower and spin less of the 2.

Not sure you need to go all the way to the end of the spectrum though - the MX500 is pretty high spin.

[sbrooke]

protopype is one of the lowest spinning shafts out there, especially in a heavier weight.

[Matt 3 Jab]

Going to try a Fuji ZCOM X flex to try and bring the spin down.

 

Otherwise my backup is a XL Tour with a V2 MOI in stiff.

 

Sound good to anyone?

[epixep]

Yeah I played an Exotics a while back... VERY hot face - and very low spin. Whiteboard is low launch

[alwaysupanddown]

7.5 Admas 4250 Tour DF White board 103 GRam X Flex Diamana Whiteboard tipped 1 inch.

If you can get it off the ground higher then 4 degree i will buy you a round at your local muni

[cb_golfer]

Going to try a Fuji ZCOM X flex to try and bring the spin down.

 

Otherwise my backup is a XL Tour with a V2 MOI in stiff.

 

Sound good to anyone?

 

 

Those shafts are not significantly different in terms of launch and spin. Do you have any launch numbers you can post?

[xdhammerbx]

everyone i talked to said the GD pershing brought down their ball flight and spin rates dropped DRAMATICALLY. if you can swing it, 75 x pershing.. its a beast! try it in a j33 460 or on a 425 tp

[Rylander]

Have the same problem, my solution was - put in Grafalloy Pl red in my 905R

[hobbygolfer]

Low launch/low spin heads:

 

J33 - 460/Bridgestone

HiBore XL Tour/Cleveland

Hyper X/Callaway

DCT/Geek Golf

 

Low launch/low spin shafts:

Whiteboard/Mitsubishi Rayon

Rombax Z/Fujikura

F7M2 LTD/Matrix

Pershing 75/GD

Protopype/Aldila

ProLite 35/Grafalloy

ProLaunch Red/Grafalloy

 

What's the best combo for you? No idea...you have to go and try some of these combos. Cheapest option would probably be to go with the Geek DCT and get a couple of shafts mentioned above. I don't think that you will find something spinning significantly lower compared to this head.

 

Best regards,

Michael

[stage1350]

I've had success with both the ProtoPYPE and Whiteboard in the J33R 460. Both will provide low launch and spin.