Possible to dismantle Arccos 360 Sensors and install into replacement Smart Grip?

I have an Arccos 360 set of sensors. However, I hate how the sensors never fit correctly and I constantly have to adjust them so they don't fall out of the grip. I've tried glue, tape, and everything I can think of but to no avail.



Has anyone tried to dismantle the 360 (screw into the butt end of the grip) sensors to see if they're the same size as the sensors in the Smart Grips? Ideally I would like to dismantle my 360 sensors and install them into a set of replacement Smart Grips. Obviously, this only works if the sensors are the same size.



Any info on the actual sensor sizes and/or how to dismantle the 360 sensors would be greatly appreciated.
Tagged:

Comments

Sign In or Register to comment.