Project X 7.0 .355 Flighted Iron Shafts

[FiveOffTheTee]

I need the 2 and 3 to match a 4-PW set that I have but cannot find them. Please chime in if you know where these can be found and purchased.

 

Thanks

[Hot Rod 71]

You can find a 3i shaft here - http://swingscience-...rallel-tip.html

 

You may be able to call them and inquire if they know where you can get the 2i, since they have the 3i-Pw.

 

On a side note: I think the difference between the flighted and non flighted PX shafts is the flighted are essentially soft stepped, regular PX shafts in the longer irons to assist in higher launch and spin. If this is true, perhaps a standard 6.0 or 6.5 in the 3 and 4 irons would accomplish what you need.

 

Here's a thread on PX vs PX flighted - http://www.golfwrx.c...s-non-flighted/

 

Here's the chart referenced in that thread.

 

Disclaimer: I'm no PX expert by any means, so this may not be 100% accurate.

[GoIrish17]

Why not just get another 3 iron shaft and put a 1/2" extension in it?

[FiveOffTheTee]

Thanks for all the work you out in here - much appreciated.

 

You can find a 3i shaft here - http://swingscience-...rallel-tip.html

 

You may be able to call them and inquire if they know where you can get the 2i, since they have the 3i-Pw.

 

On a side note: I think the difference between the flighted and non flighted PX shafts is the flighted are essentially soft stepped, regular PX shafts in the longer irons to assist in higher launch and spin. If this is true, perhaps a standard 6.0 or 6.5 in the 3 and 4 irons would accomplish what you need.

 

Here's a thread on PX vs PX flighted - http://www.golfwrx.c...s-non-flighted/

 

Here's the chart referenced in that thread.

 

Disclaimer: I'm no PX expert by any means, so this may not be 100% accurate.